Practical method for eliminating blockage of sand and gravel separation equipment

Since the configuration of the sand and gravel separation equipment is not the same, occasionally, in the production process, the material is broken or cannot be broken. If you encounter problems with the sand and gravel separator blockage, first stop the machine's operation, and then eliminate the cause one by one to find the corresponding solution. And to master the [the right medicine] to eliminate the practical method of sand and stone separation equipment blockage.

 

    1. There is a problem with the design of the sand and gravel separator or the improper use of the operator.

 

    In this case, the air supply port should be cleared first, the mismatched conveying equipment should be changed, the feeding amount should be adjusted, and the new sand making machine equipment should be operated normally; and skilled operators or professional training should be given to the operators.

 

    2. The feeding speed is too fast and the load is increased, which causes the sandstone production line to be blocked.

 

    Therefore, in the feeding process, it is necessary to pay attention to the problem that the current meter pointer has a large deflection angle. If the rated current is exceeded, it indicates that the motor is overloaded and overloaded for a long time, which will burn the motor.

 

    When this happens, the door should be lowered or closed immediately, or the feed should be changed, and the feed should be controlled by adding a feeder.