Sand stone separator debugging requires heavy details

Small details often have a large impact, especially in the installation and commissioning of sand and gravel separator equipment, the details of which have an important impact on the sand and gravel separator. Therefore, when installing and debugging the sand separator, pay attention to the following details.

 

     1. Due to the large twist of the machine, it is recommended to install the machine on the concrete foundation. The pre-embedded weldment is installed on the foundation for welding during installation. The foundation depth and area are calculated separately according to the soil condition. It is recommended that the base weight is roughly the weight of the machine. 3 times, the machine installation dimensions refer to the base map.

 

     2. After the installation is in place, check whether the gear of the reducer is displaced, whether the gap between the water tank and the big wheel bucket is the same. After the adjustment, fix the machine to the foundation.

 

     3, should add lubricant, adjust the oil level, generally take 50% below the shaft center is appropriate.

 

     4. After the machine is installed and adjusted, the test run should be carried out. The no-load test should reach:

 

     1 continuous operation for 2 hours:

 

     2 All solid parts should be firm and free of looseness:

 

     3 There is no abnormal sound in the reducer and gear box.